User should specify the required *power in kW per set in order to gain the following:
1-Wind speed, m/s
2-Rotor diameter, m
3-Tower height, m
4-Initial cost, $
5-Number of wind turbines, #
6-Torque, N.m
7-Rotor speed, RPM
8-Power coefficient
*Note That The power range is 0.2-50 kW
**Watch the video via:
https://www.youtube.com/watch?v=jzC9fAl-GdM&t=3s
https://youtu.be/jzC9fAl-GdM
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
Suez University, Suez EgyptFaculty of Petroleum & Mining EngineeringEgineering Science Deptmohammed.eldeen@suezuniv.edu.eg, mwahab31@yahoo.com
00601139795943
All Rights Reserved
___________________
Vertical Wind Turbine Model
VWT model is a part from WDS library. User can assign the module power and the total farm power in kW.
User can reform the model based on his need.