This model is a performance model based on single effect evaporation desalination process. User can assign the feed operating conditions (salinity, flow rate, temperature) and eevaporator area. The following parameters will be calculated:
1-Steam temperature and flow rate.
2-Performance ratio.
3-Brine blow down operating conditions.
4-Distillate product operating conditions.
5-End condenser parameters.
Dynamic model is considered. User can set the simulation time as "inf" and change the
input data based on his need.
 
**MatLab-SimuLink (64bit) should be used to run the model.
 
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or 
transmitted in any form or by any means, including photocopying, recording, 
or other electronic or mechanical methods, without the prior written permission 
of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, 
write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
 
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved
___________________