This model is about desalination and power generation by the use of concentrated solar tower system (CST) combined with MEDpf configuration. User can assign the production rate of fresh water in order to obtain all design aspects such as:1-CST field design (area, No. of mirrors, tower height, etc..).2-Design aspects for steam Rankine cycle.3-All operating conditions and design limits for MEDpf.4-Cost analysis are considered.5-Energy, Exergy, and thermo-economic streams are calculated.6-Molten salt heat transfer fluid is used through the CST.7-Toluene is used for Organic Rankine Cycle (ORC).8-Boiler heat exchanger-Storage unit is used as an intermediate unit.9-Single storage with embedded pump unit is used.10-Two storages are used in this model (gold and hot).All cycles are prepared for dynamic and fixed point modeling. All cycles are designed for desalination and electric power generation.
**MatLab-SimuLink should be used to run the model.email us for the password (msherafeldin@gmail.com)
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved___________________
Concentrated Solar Tower for ORC Multi Effect Distillation and Power Generation
User can reform the model based on his need. Dynamic modeling is allowed.
The model is used of electric power generation and thermal desalination.