This is a chilled water system by the use of Absorption Refrigeration cycle. Refrigeration cycle utilized LiBr/water refrigerant. There are four basic heat exchanger surfaces: the evaporator, the absorber, the generator, and the condenser, in addition to a liquid-liquid heat exchanger. Lithium bromide is, basically, nothing more than salt water. However, lithium bromide is a salt with an especially strong attraction for water. Mechanical draft cooling tower is used for the absorber/condenser cooling issues. User can assign the chilled water mass flow rate load requested by the user based on his design. The user flow rate will calculate the cooling load through the cycle. PID controller is considered for the dynamic model.
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved.
No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests,
write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved
___________________
Absorption Chilled Water Cycle-PID (Water LiBr)
You can get your discount code from services page, or ask for it via chatting with Prof Dr Mohamed A Sharaf Eldean.